How To Make A Popcorn Machine Out Of A Coke Can

#1

Here's what you'll need:

2 clean, empty soda cans

waterproof pen

sharp knife

scissors

hammer

Here's how to do it:

Using the waterproof pen, draw a rectangle on the side of a can with a gap in the middle of the top side.

#2

Cut it out with the knife and bend it outwards. The top side should remain attached as a small door.

#3

Cut the top end off the second can, leaving about 2/3 of the original there. Clean up the edge with some scissors in case it is rough.

#4

Draw two rectangles on the remaining end and completely cut them out.

#5

Hold the can and carefully hammer the base of the can until it's slightly bent outwards.

#6

Cut the remaining "teeth" 3-4 times along the top edges and fold them inwards.

#7

It should be easier after you cut it. Your can should look like this:

#8

Place a lit tealight in the can that you hammered and place the other can ontop. Don't forget to place a bowl in front of the door so the popcorn doesn't fly everywhere!

#9

Pour a few kernels in through the drink spout... microwave popcorn works well because it is already flavored.

#10

It takes a little while to get your first "pop," but then all the kernels will start popping one after the other into your bowl.

Important warning: Remember the can will get HOT. Make sure you place your can on a heat-resistant surface and let it cool down before touching it.

#11 Here are video instructions: